[pro-see-yon]

Contour Routing:

Contour routing is accomplished using a 0.6mm (23.6 mil) or larger contour router tool. Please make sure all inside radius cuts are acceptable to use with a 0.6mm tool.

Slot Outlines:

Slots may be milled in the board. Thinner boards may use a small end mill cutter to make the slot, but boards thicker than 20 mils will need to have a minimum slot width of  20 mils.

There are no additional charges for slot outlines or contour routing. 
 

Send mail to admin@procyonpcb.com with questions or comments about this web site.
Copyright © 2006 Procyon PCB Inc
Last modified: 10/29/08